Home Home  Forum Forum  Jobs Jobs  Resources Resources  Invite Invite  Shoutbox Shoutbox  Messages Messages  Profile Profile  Search Search  Calendar Calendar  Shrek Report Shrek Report  
Last Shout - Posted by: Matt - Saturday, 14 August 2010 23:25
Well, it's been dead around here for a while. I guess it just isn't going to catch on. Sucks because there was a ton of money and time invested in this place. Has all the potential to be the most resourceful inspection website around, but if it isn't used then what's the point? Anyways, thanks to all that have contributed so much. The lights will be off soon....Matt
InspectionGroup.Org
September 09, 2010, 11:52:26 AM *
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
News: If you are looking to post jobs or are a service company, PM me and I will set you up to add jobs. Matt
 
Pages: [1]
« previous next »
  Print  
Author Topic: ASME basic block for angle beam calibration  (Read 346 times)
DavidPT40
FNG
*
Posts: 25


View Profile Email
« on: October 31, 2009, 12:09:42 PM »
I know that article 4 of section 5 provides the basic plans on how to build a basic calibration block for ultrasonics.  But in practice, I have come across many different variations of that block.  Some are much longer than others, have notches that have been rounded, have holes in different locations.  I am looking for plans that have these tweaks incorporated into them, especially for API usage (.75" and 1.5").  Can anyone help me out on this?
« Last Edit: November 06, 2009, 05:02:09 PM by DavidPT40 » Logged
Pages: [1]
  Print  
« previous next »
 
Jump to:  

TechGG by Zeuder


MKPortal C1.2.1 ©2003-2008 mkportal.it
Page generated in 0.01834 seconds with 11 queries